Toshiba Qosmio G40 Bedienungsanleitung PDF herunterladen (Seite 172)

9-12 User’s Manual

Qosmio G40

Point to note about memory module error

If you install a memory module that is not compatible with the computer, the

Power indicator will flashes (on for 0.5 seconds, off for 0.5 seconds) in the

following ways;

■ If there is an error in only Slot A or no memory module is inserted in Slot

A: repeatedly flashes orange twice, then green.

■ If there is an error in Slot B: repeatedly flashes orange, then green

twice.

■ If there are errors in both Slot A and Slot B: repeatedly flashes orange

twice, then green twice.

In all instances you should shut down the computer and remove the

incompatible module(s).

Installing a memory module

The computer contains slots for two memory modules, one positioned

immediately over the other - the procedures are the same for installing

either module.

1. Set the computer to Boot Mode and turn its power off - make sure the

Power indicator is off (refer to the Turning off the power section in

Chapter 3, Getting Started, if required).

2. Remove the AC adaptor and all cables and peripherals connected to

the computer.

3. Turn the computer upside down and remove the battery pack (refer to

Replacing the battery pack section in Chapter 6, Power, if required).

4. Loosen the two screws securing the memory module cover in place -

please note that this screw is attached to the cover in order to prevent it

from being lost.

5. Slide your fingernail or a thin object under the cover and lift it off.

Removing the memory module cover

Use a #0 point Phillips screwdriver to remove and fasten the screws -

the use of an incorrect screwdriver can damage the screw heads.

Memory module cover

Screws

1 2 ... 167 168 169 170 171 172 173 174 175 176 177 ... 255 256

Keine Kommentare

Toshiba Qosmio G40 Bedienungsanleitung Seite 172